How to transform the lighting and sound in the dance hall

1. The dance hall is a public entertainment place, mainly for accommodating many people to dance and sing, so there will be a large area when designing professional audio lighting, usually the dance floor is actually smooth, and the reflective surface is Very strong

2, directly above the dance floor of the dance hall, under normal circumstances, the design will have a ceiling, the ceiling is designed with a light stand, the main installation of the light stand is to install like art lighting, performance lighting, audio equipment, video equipment, etc.;

3, the general situation In the professional audio project, the dance floor and the stage are usually in a space, because this will not only have a "sound field" concept.

The characteristics of the dance hall in the sound quality are mainly as follows: the volume is large, from the sound level data, there is 95dB size, and it is not the limit value, there is a margin of 6-10dB, if the disco music is played in the ballroom, the sound The level will reach 110dB, so the sound field conditions of the dance hall are very complicated, and its acoustic design is more difficult than the theater design.

In the professional audio engineering transformation of dance halls, there are usually many factors to consider. In general, the proportion of the height, width and length of a room is a part that must be considered. Therefore, when the design ratio is appropriate, the resonance frequency distribution in the space usually More uniform, but if professionally speaking, there is a golden ratio in field science: 0.618:1:1.618.

In the professional sound engineering lighting of the dance hall, in general, the scaffolding part of the upper part of the dance floor is mainly used to install effects lamps and performance lamps, so the height is usually high, and the top grid at the lamp holder is required. With a certain height, because there is a certain height to ensure a good angle of illumination, with a good angle and coverage, there is a suitable sound coverage.

In the smooth ground of the dance hall, if the launching is strong, the sound quality in the hall will be affected, so we must arrange the sound absorbing material of sufficient thickness in the top grid of the upper part of the grid. If it is necessary to adopt the modeling requirements, it is necessary. The surface is acoustically designed.

In professional audio engineering, the sound control room is usually the brain of the dance hall. This is because the control of sound, video and lighting all depends on it. With the development of technology, the number and types of equipment in the stage design will come. The more and more, the more complex, so there will be more and more operators and managers.

In the dance hall, the area of ​​the dance floor should not be too small. This is to consider its expandability. In general, the size is recommended to be controlled above 20 square meters, and the professional sound engineering should be placed in front of the stage, so that the audience or performers When interacting, you can visually see and manage and adjust according to actual needs.

• Raw Material:Copper Rod or Aluminium
• Drawing Rolling :Convert 12.5 mm or 8 mm size of copper rod to size of clients' requirement.
• Annealing:Heat resistance
• Japanning: Painting the copper conductor.
• Finished Products :Copper or aluminum wire
• Detection:check the quality of finished products through the machine.
• Packing :PT25/60/90/200 or others
• Shipping :Container

Enameled Aluminium Wire

Enameled Aluminium Wire,Transformer Enameled Aluminum Wire,Polyester Enameled Al Round Wire,Aluminum Wire Winding Magnetic

HENAN HUAYANG ELECTRICAL TECHNOLOGY GROUP CO.,LTD , https://www.huaonwire.com