Automatic mixing material mixer notes - Huaqiang Electronic Network

MOS Power IC Full Range

KKST Patch Plug-in Active/Passive Crystal Oscillator, Hot Sale 24.576000MHz

Automatic Mixing Machine

Precautions:

1. When the heating pot reaches the set temperature, there is a temperature overshoot phase. This occurs because the heater continues to transfer heat to the pot even after it has been turned off, causing the temperature to keep rising for a short period.

2. When testing the temperature control system, it's important to place a certain amount of heating material in the pot, such as stones, sand, or water. This helps transfer the heat from the pot surface to the object being heated, reducing the temperature overshoot. Otherwise, the temperature inside the pot may be much higher than the set value, leading users to mistakenly believe the system is faulty.

3. Temperature Error:

The temperature controller measures the temperature on the surface of the heating pot, which may differ slightly from the temperature at the center of the pot. This is a normal occurrence, and users should rely on the set temperature as the standard for operation.

4. During storage and transportation, the instrument may be exposed to humid air, which can reduce the insulation performance of the electrical components. The heater, in particular, might experience a drop in performance. At the start of power-on, you may feel some tingling or numbness. However, this will resolve within a few minutes once the heater is turned on. Always ensure the device is properly grounded before use. Connect the grounding terminal to the grounding hole of the power socket. Failure to do so may result in risks, and the user will be responsible for any consequences.

5. The lifting rod must be regularly lubricated with grease, at least once per shift, to ensure smooth operation and prevent wear.