Automatic mixing material mixer notes - Huaqiang Electronic Network

MOS Power IC Full Range

KKST Patch Plug-in Active/Passive Crystal Oscillator - Hot Sale, 24.576000 MHz

Automatic Mixing Machine

Precautions:

1. When the heating pot reaches the set temperature, there may be a temperature overshoot phase. This happens because the heater continues to transfer heat to the pot even after it is turned off, causing the temperature to keep rising for a short period of time.

2. When testing the temperature control system, make sure to place some heating material in the pot, such as stones, sand, or water. This helps transfer the heat from the pot's surface to the object being heated, which can help reduce temperature overshoot. If no materials are used, the temperature inside the pot might rise significantly above the set point, leading to confusion and mistaken belief that the system is faulty.

3. Temperature Error:

The temperature controller measures the temperature on the surface of the heating pot. However, the actual temperature at the center of the pot may differ slightly due to thermal distribution. This is a normal occurrence, and users should rely on the set temperature as the reference point.

4. During storage and transportation, the equipment may be exposed to humid air, which can affect its insulation performance. This is especially true for the heater, which may experience more significant degradation. At the beginning of power-on, you might feel a tingling sensation due to this. However, turning on the heater will resolve this issue within a few minutes. It is essential to ensure the device is properly grounded before use. Connect the grounding terminal to the grounding hole of the power socket. Failure to do so could lead to safety risks, and the user will be responsible for any resulting consequences.

5. The lifting rod should be lubricated regularly—preferably once per shift—to ensure smooth operation and prevent mechanical wear.